Seam repair
Panel joints are cleaned and resealed so water stops getting through.
A roofer in Vernon can repair a mobile home roof by resealing open seams, replacing loose fasteners, sealing vents and the AC curb and recoating the roof so it sheds water again. Call (973) 858-1840 to reach a local roofer for mobile home roof repair.
A mobile home roof has its own weak points, and most leaks start at the same few spots. The roof might be metal panels, an EPDM or TPO membrane, or asphalt shingles on a pitched roof, depending on the age and model of the home. On metal roofs, the seams between panels, the screws holding them down and the sealant around vents, skylights and the AC unit are where water gets in.
A slow drip can do more harm in a mobile home than in a typical house. Thin ceiling panels stain and bow, insulation gets soaked and the wood framing can start to rot before the leak is obvious. A ceiling sagging with water can be drained through a small hole into a bucket, away from any light fixture, with power to that area shut off at the panel if the panel is safe to reach.
Mobile home roofs are not built to be walked on like a house roof. Weight should go on the trusses, not between them, which is why roofers often use boards to spread their weight. Never go up when the roof is wet or icy, and check the data plate inside the home, which lists the roof load zone the home was built for.
Many mobile home roof repair calls in Vernon also turn up a need for roof coating or metal roof repair.
Looking for Vernon mobile home roof repair? Call (973) 858-1840 and describe the problem to a roofer who works in Vernon.
Call nowThe fix depends on the roof type and how far the water has spread.
Every seam, screw, vent and edge is checked, along with low spots where water sits. Stains on the ceiling inside help narrow down the source.
Loose or stripped screws are replaced with larger fasteners that have new rubber washers, and loose panels are fastened down so they stop flexing. Surface rust is wire brushed and primed.
Panel seams are cleaned and sealed with butyl seam tape or a reinforced seam sealer. On rubber roofs, the roofer patches with matching membrane and lap sealant.
Every roof penetration is resealed, with brittle vent caps or skylight domes replaced. The edge rail around the roof is resealed too.
On metal and some membrane roofs, a full elastomeric or silicone roof coating is applied after repairs to seal small gaps and reflect sun. Coatings need dry weather and a clean surface to bond.
Panel joints are cleaned and resealed so water stops getting through.
Vents, skylights and the AC curb are resealed or new flashing where needed.
Rotted sheathing or framing under leaks is repaired before new roofing goes over them.
The roof is recoated after repairs which slows rust on metal.
Loose and rusted screws are replaced with gasketed fasteners to close leaks at every screw.
When repairs cannot keep up, a mobile home roof replacement removes the old roofing and installs a new system. Replacement may include new sheathing over the trusses, fresh insulation and a new roof of metal, rubber membrane or TPO. Damaged trusses are fixed first.
For mobile home roof replacement in Vernon, the roofer has to plan around light framing and the roof load the home was built for. A permit may be required, and rules for manufactured homes can differ from site-built homes, so the roofer should check local requirements. Done right, the new roof should end the cycle of patching.
A mobile home roof over installs a new roof on top of the existing one instead of tearing it off. Roof overs range from low slope membrane systems over foam board to framed pitched roofs topped with shingles or metal. Most roof overs also add insulation, which helps with comfort and with the noise of rain on metal.
A mobile home roof over in Vernon has to fit the structure of the home, so the added weight and how the new roof attaches are checked first. Pitched roof overs in particular may need engineering and a permit, and they should be anchored to resist wind uplift. A good roof over ends the seam and screw leaks that plague old metal roofs.
Mobile and manufactured homes in Vernon range from older single and double wides with metal roofs to newer homes with pitched shingle roofs. Owners in Vernon and neighboring communities such as Hamburg, Highland Lakes, Franklin and Oak Ridge often find that a well kept coating is the difference between a dry roof and a leaking one, and storms with strong wind are what loosen fasteners and lift edges.
Searching for mobile home roof repair near me from Vernon or Hamburg, Highland Lakes, Franklin and Oak Ridge? Call (973) 858-1840 to talk to a roofer who works in your part of town.
Cold winters bring snow, ice and a long stretch of freezing nights. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, which is how ice dams form and back water up under the shingles. Strong coastal storms push rain into every weak spot at the flashing and valleys. Most homeowners in Vernon, NJ have the roof checked in the fall and again after the snow melts.
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Roofers in Vernon know the roof types and weather wear common in local homes.
Ask your questions before you agree to anything.
More questions? Call (973) 858-1840
A seamless coating over a sound but weathered roof, after the seams and blisters are repaired.
Learn moreRepairs for leaking fasteners, open seams, rusted panels and failed flashing on a metal roof, so the panels keep shedding water for years more.
Learn moreEPDM rubber roof repairs done with primer, cover tape and lap sealant made for rubber, so the membrane seals again without a tear-off.
Learn moreFinding where water gets through the roof and sealing it at the source, before wet decking and insulation turn into rot.
Learn moreLooking for something else?
See all roofing servicesCall (973) 858-1840 to talk to a roofer serving Vernon, NJ.