Deck repair
Damaged structure is repaired for a straight, solid roof.
Metal Roofing
Metal Roof Replacement Vernon, NJ
When an old metal roof in Vernon leaks in too many places to chase, replacement with new panels usually makes more sense than another round of screws and sealant, and help you decide between a tear-off, a re-cover or new panels in just the bad sections. One call to (973) 858-1840 reaches a nearby roofer who replaces metal roofs.
Replacement comes up once rust or wear has spread past what patches and new fasteners can fix. Rust that has eaten through panels in many places, paint that has chalked and worn down to bare metal and screw holes that have wallowed out across the whole roof all point toward new panels. Thin panels from decades past are usually the first to rust through.
Not every metal roof replacement starts with a tear-off. Tearing off lets the roofer see rotten purlins, soft decking and rusted fasteners before anything new is installed. Retrofit re-covers add a new metal roof over the old one, attached through to the structure.
A big share of metal replacement work is switching a worn shingle roof to metal. Depending on code and deck condition, the old shingles are either removed or covered. Before calling, note the roof age, the type of panels or shingles on it and where it leaks.
Many metal roof replacement calls in Vernon also turn up a need for metal roof installation or metal roof repair.
Looking for Vernon metal roof replacement? Call (973) 858-1840 and describe the problem to a roofer who works in Vernon.
Call nowThe process
What happens during a metal reroof
Here is how a metal replacement usually goes.
Inspect the structure
The roofer counts rust-through spots, checks the finish and inspects the purlins or decking from inside the attic or building. This decides tear-off, re-cover or partial panel replacement.
Plan the new roof
Tear-off, re-cover or metal over shingles is chosen, along with the new panel system, gauge and finish. Switching to standing seam usually means adding solid decking.
Remove the old roof
The crew unscrews and lifts off the old metal, stacking it for recycling. The roof is never left open overnight.
Fix the purlins
The structure is repaired so new fasteners bite into solid wood. Sound framing is what keeps the new roof fastened.
Panel the roof
High-temperature underlayment, new trim, panels, closures and flashing go on in order from the eaves up. Gutters may be reset to match the new eave line.
What is included
What metal roof replacement includes
Tear-off
Old metal panels, trim and fasteners are removed section by section.
New trim
All new eave, rake, ridge and wall trim so the details last as long as the panels.
New panels
Fresh metal cut to length for each slope go on over new underlayment.
Retrofit framing
A retrofit re-cover avoids a tear-off with fasteners driven into the structure below.
Related service
Metal Roof Panel Replacement Vernon, NJ
Metal roof panel replacement swaps out individual damaged panels instead of the whole roof. On exposed fastener roofs, the roofer removes the screws on the damaged panel and the overlapping edges of its neighbors, slides it out and sets a new one in sealant. Standing seam panels can be replaced too, but it takes more work to unseam and reseam the neighbors.
Many Vernon roofs need only a few panels replaced after a storm or a falling limb. Color matching is the main limit, since new paint looks brighter than weathered panels. Too many swaps, and a full reroof is the smarter route.
Related service
Metal Roof Over Shingles Vernon, NJ
Putting a metal roof over shingles means installing new metal on top of one existing layer of asphalt shingles instead of tearing them off. Where code permits, the roofer adds underlayment or furring strips over the shingles and fastens the metal through to the deck.
What you give up is a look at the deck. Before going over shingles on a Vernon home, the deck is checked from inside and any soft areas are found. Any sign of rot, or a second layer of shingles, tips the decision to tear-off.
Local help
Metal Roof Replacement Near Me
Around Vernon, metal reroofs range from rusted farm buildings to houses getting their first standing seam roof. From Vernon out to neighboring towns such as Hamburg, Highland Lakes, Franklin and Oak Ridge, older metal roofs tend to need full replacement once the coating is gone, and newer houses are adding metal as their shingle roofs wear out, which is why the condition of the purlins and deck drives the plan.
Need metal roof replacement around Vernon? Call (973) 858-1840 for a Vernon roofer who serves the towns around it too.
Roofs in this climate
Cold winters bring snow, ice and a long stretch of freezing nights. When warm attic air melts the snow, the meltwater runs down and freezes again at the eaves, building ice dams that push water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. Most homeowners in Vernon, NJ have the roof checked in the fall and again after the snow melts.
Why call
Why not wait
Drier ceilings
Small roof problems caught early usually stay small repairs.
Roofers who know Vernon
Roofers in Vernon know the roof types and weather wear common in local homes.
Clear next steps
Ask your questions before you agree to anything.
Metal Roof Replacement questions
Can a metal roof be installed over shingles?
Where code permits, metal can go over a single layer of shingles. It works best when the deck is sound and the shingles lie flat. Two layers or any rot means the shingles should come off.
Can a new metal roof go over the old metal roof?
A retrofit, or re-cover, installs new metal over the existing panels using a sub-framing system. The method is popular on commercial buildings and large outbuildings. The framing must be sound enough to support both layers.
When does a metal roof need replacing instead of repair?
The tipping point comes when rust or wear is spread across the roof, not just in a few spots. If panels are perforated, the coating is gone and the fasteners no longer hold, patches will not keep up. A call to (973) 858-1840 is a good way to find out where the roof stands.
How is a single metal roof panel replaced?
Replacing one panel is a routine job on most ribbed and corrugated roofs. The roofer unscrews the panel and its laps, removes it and fastens a matching one in place. Concealed fastener panels are possible but slower to replace.
What happens to the old metal roofing?
Metal roofing is one of the most recyclable building materials. The old panels and trim are separated and sent to a recycler. Your roofer can explain how the old metal will be hauled away.
More questions? Call (973) 858-1840
Other services that may help
Metal Roof Installation
Choosing and installing a metal roof, from panel type and gauge to underlayment, trim and closures, for homes, garages and outbuildings.
Learn moreMetal Roof Repair
Repairs for leaking fasteners, open seams, rusted panels and failed flashing on a metal roof, so the panels keep shedding water for years more.
Learn moreRoof Replacement
A complete new roof from the deck up when repairs no longer make sense, so the house is dry for decades instead of seasons.
Learn moreStanding Seam Metal Roof
Standing seam metal roofing installed, repaired and detailed for thermal movement, built to let the metal move without leaking.
Learn more
Looking for something else?
See all roofing servicesTalk to a Vernon roofer about metal roof replacement
Call (973) 858-1840 for a local roofer in Vernon and nearby towns.